The Fire Trainer was specially developed for use in fire and rescue drills, but also feels right at home during film productions or beach parties. Thanks to the stainless steel housing and the high-quality fittings, the device is waterproof, according to IP 64. Due to the extremely efficient use of the available energy, the fog output is considerably higher than with many comparable devices from the Far East. Equipped as standard with an IP 64 analogue connection, the Fire Trainer can be controlled with a radio remote control or a wired remote control. In addition, the optionally available timer or DMX converter can also be connected. In addition, the analog input offers the possibility of controlling the device via PLC. Of course, the Fire Trainer, like almost all Smoke Factory machines, can also be used in stand-alone mode. In stand-alone operation, the nebulization process is started by pressing the start button once. If this is not pressed repeatedly, the machine will fog up until the temperature limit is reached. With the rotary switch you can choose between three different smoke modes. In the first stage, the unit fogs until the lower limit temperature is reached and automatically stops the fogging process. At Level 2, the unit automatically lowers when the temperature in the heater drops, causing continuous fogging of the Fire Trainer. On the third stage, the unit starts directly on the reduced power which it can maintain permanently. The permanent temperature control on the microprocessors guarantees the correct evaporation temperature at all times. This ensures that no harmful substances are produced by too hot evaporation or that the device "spits out" unevaporated fluid. Like all devices